How to Switch from USB to Ethernet Cable
Switching from USB to Ethernet cable is very easy without having to install any Ethernet card. Most of the broadband Modems have the capacity to support two types of network connections which are USB and Ethernet. Both of them serve the same purpose. It is possible for you to alternate between the two networks whenever you need to but the two cannot be used simultaneously. But before switching, it is necessary to understand the differences between the two connections. It is generally believed that Ethernet is a preferred option between the two for some reasons. Differences between USB and Ethernet Some of these reasons include the following: it is possible for Ethernet cable to get to a longer distance than the USB would. You can use a single Ethernet cable within the whole house but the USB cannot go that far, as a matter of fact, USB has a limited coverage of about sixteen feet. Ethernet cable is technically more dependable than the USB for networking. It very unlikely to have a slow connection when using the Ethernet compared to USB. Another advantage that Ethernet has over USB is that with Ethernet, you do not need any installation of device driver software. Ethernet also provides higher performance rate in networking compared to USB. Converting USB to Ethernet In addition to this, when you are using Ethernet, it is possible for you to connect to DSL modems, network connections or cable modems, and browse at a very high speed. It is also possible for you connect to a shared network to share internet connections and printers and you can also connect between multiple computer systems to share files. To switch from USB to Ethernet cable, you will need to USB to Ethernet plug and play cable and an Ethernet cable. The first thing to do is to turn on your computer and insert the USB end of the cable to the available USB port that is on your computer. Then connect one end of the Ethernet cable to the adapter. Now connect the other end of the Ethernet cable to your router, network hub, or modem. Your system may prompt you to install some drivers, install them. If you are asked to insert any CD that might have come with the adapter, insert the CD and follow the instructions. After this process, your USB port has been converted to an Ethernet connection and you can use the connection for Ethernet based purposes. Configure the network by going to Control Panel. Make sure you do not force the cable connection into a port as it can damage the port. Read more details about usb to ethernet cable and ethernet cable.